Weber 4000 Manuel d'utilisateur télécharger pdf (Page 17)

Slot in frame

(view from below)

Insert one end of the hinge rod into the hole in the

frame. Figure 18 (a).

Insert the other end into the hole in the swing table end

bracket. Figure 18 (b). Hold the end bracket at an angle so

the lower tab is inside the frame tube. Push the bracket into

the frame. Check to see that the lower tab of the bracket is

hooked in the slot in the frame. Figure 18 (c).

To fully seat the bracket, you may have to tap it lightly with a

hammer.

WARNING: If swing table end bracket is in any

way cracked or damaged, do not use swing table.

Call our Customer Service Center to order a new

part.

WARNING: The load limit for the swing table is

30 pounds.

Figure 18

(c)

View from rear

of barbecue

Hinge rod

(b)

(a)

Step 15

Install left hand swing table

You will need: swing table end bracket, two 10-24 hex

nuts, two 10-24 x 1 3/4 inch machine screws, left hand

slide bar assembly, swing table, four nylon washers,

screwdriver and pliers.

Allow the slide bar to hang down. Push the support rod

into the lower support bracket. Figure 17 (a). Swing the

rod up so you can slide the rod all the way inside the

locking tab. Figure 17 (b). The rod should swing freely

inside the locking tab. Figure 17 (c).

Figure 17

(a)

(b)

(c)

Support rod

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Pas de commentaire

Weber 4000 Manuel d'utilisateur Page 17